Routine Maintenance
Transmission
164 164
9811-3400-4
Transmission
Gearbox
Checking the Oil Level (Engine Running)
Important: Before you open the engine cover, you must
allow the engine to operate at low idle for four minutes. The
delay allows the coolant temperature to stabliise before
you open the engine cover.
Note: The transmission oil level should be checked only
when the oil is at the correct working temperature.
1 Make the machine safe with the loader arm lowered.
Refer to Prepare the Machine for Maintenance.
Do not stop the engine.
2 426, 436: Open the left side engine cover.
456: Open the right side top step.
3 Remove, wipe and replace the dipstick A.
Note: Turn ‘T’ handle D, two full turns counter-clockwise to
release the dipstick. Turn ‘T’ handle D, two full turns
clockwise to fasten in position. Check that the dipstick is
secure.
4 Make sure the oil is at the correct mark on the
dipstick.
5 If necessary, add recommended oil at dipstick/filler
point A.
Note: The transmission may overheat if the oil level is
above the HOT mark.
6 Close and lock the engine cover.
812160-1
Fig 120. 426, 436
797320-1
Fig 121. 456
To Next Page
Loading...
