Optional Attachments
Quickhitch Control
190 190
9811-3400-4
Engage the Attachments
In this procedure to engage the attachment, the Quickhitch
isolator switch is used to divert the hydraulic power. If your
machine has a power diverter lever substitute this in the
procedure for the Quickhitch Isolator Switch.
1 Align the machine square with the attachment.
2 Lower the loader arms to move pivot shaft E below
the level of the hooks F on the attachment.
3 Drive the machine slowly forward, stop when the pivot
shaft E just touches the attachment.
4 Apply the park brake and put the transmission in
neutral.
5 Lift the loader arms and engage the pivot shaft into
the hooks. Stop the movement as soon as the pivot
shaft is engaged.
6 Engage the attachment:
Servo-controls lever: Move the lever D to the left and
tilt the Quickhitch fully back.
Multi-controls lever: Move the lever X to the rear and
tilt the Quickhitch fully back.
7 Push and hold the Quickhitch isolator switch. (If
fitted).
8 Engage the locking-pins:
Servo-controls lever with an auxiliary lever: Pull the
lever B until the locking-pins A are engaged.
Servo-controls lever with an auxiliary button: Push
the button C until the locking-pins are engaged.
Multi-controls lever: Pull the lever Z until the locking-
pins A are engaged.
9 Make sure the locking-pins in the base of the
Quickhitch are fully engaged.
10 Release the Quickhitch isolator switch.
11 if necessary, connect the hydraulic hoses. K
Quick
Release Couplings ( T 185).
801590-2
Fig 144.
T012730-4
Fig 145. Servo-controls lever with auxiliary lever
T013150-2
Fig 146. Servo-controls lever with auxiliary button
D
B
To Next Page
Loading...
