jcb 426 - Safety Equipment; Control Lever Locks

Operation
Safety Equipment
61 61
9811-3400-4
Safety Equipment
Control Lever Locks
Loader Arm Control Isolator Switch
To prevent the hydraulic loader arm controls from being
operated accidentally when the driver is entering or leaving
the cab, a joystick isolation switch has been installed
K
Right Console Switches ( T 43)
The loader arm controls must always be locked before the
driver leaves the cab.
The loader arm controls must only be unlocked when the
driver is correctly seated and there is no danger of
accidentally knocking against the loader arm control
levers.
Neutral Lock
P4-2008
!MCAUTION
Do not operate the Forward/Reverse switch when
already using the Forward/Reverse lever, otherwise
the transmission will select neutral. When using the
Forward/Reverse switch, the Forward/Reverse lever
MUST be locked in neutral.
4-2-1-6_2
To prevent accidental operation of the forward/reverse
lever, while entering or leaving the cab, the lever can be
locked in the neutral position.
With the selector in the position marked N, the lever is
locked in neutral.
With the selector in the position marked D, forward or
reverse drive may be selected.
S200371-1
Fig 43.
Loader Arm Controls
Unlocked or Active
Switch On (Illuminated)
Loader Arm Controls
Locked
Switch Off