Routine Maintenance
Fuel System
156 156
9811-3400-4
Sedimentor Bowl
Draining the Sedimentor Bowl
1 Make the machine safe with the loader arm lowered.
Refer to Prepare the Machine for Maintenance.
2 Open the rear grille. Refer to Access Panels - Rear
Grille.
3 Drain off any water in the bowl by turning tap A and
slacken screw E.
4 Make sure tap A is turned off and secure. Tighten
screw E.
5 Close and lock the rear grille.
!MCAUTION
Running the engine with air in the system could
damage the fuel injection pump. After maintenance,
the system must be bled to remove any air.
2-3-3-11
Cleaning the Sedimentor Bowl
If bowl B contains sediment carry out the following:
1 Hold the bowl B and unscrew domed nut C.
2 Remove the bowl, and wash in clean fuel.
3 Clean strainer D.
4 Refit the bowl. Make sure the gasket is in good
condition and positioned correctly.
5 Re-tighten nut C, taking care not to over-tighten.
6 Bleed the fuel system. K
Bleeding the
System ( T 157).
S261720
Fig 111.
E
C
D
B
A
To Next Page
Loading...
