Operation
Drive Controls, Switches and Instruments
55 55
9811-3400-4
Heater/Air Conditioning Controls
1 Fan.
Turn the switch to start the three-speed heater fan.
Turn the switch more to get faster fan speeds. The fan
operates only with the starter key in the IGN position.
2 Temperature.
To increase the temperature, turn the switch to the
left.
3 Re-circulation.
To re-circulate the air in the cab, turn the switch to the
left.
To get fresh air from outside of the cab, turn the switch
to the right.
Adjust the switch to get a mixture of re-circulated and
fresh air.
Note: In dusty conditions, it is recommended to re-
circulate the air in the cab, if not the filter can become
clogged.
4 Air Conditioning.
To start the air conditioning, turn the switch to the left.
When the air vents are open, hot or cold air flows directly
into the cab.
To quickly de-mist the front window, close the air vents and
turn the air re-circulation control switch fully to the left.
The circular adjustable air vents are on:
– The front of the side console at foot level (2 off).
– The front console (2 off).
– The top of the rear bulkhead (2 off).
– The top at the rear of the side console (1 off).
– The rear bulkhead (A smaller air vent).
Two rectangular adjustable air vents are found on either
side of the front console.
806590
Fig 36.
0
-
1
-
2
-
3
O
N
O
F
F
4
3
2
1
To Next Page
Loading...
