Operation
Preparing the Machine for Travel
68 68
9811-3400-4
Preparing for Site Travel
Read and understand the information given in Preparing
the Machine for Travel.
!MWARNING
High Loads
A high load can block your view and reduce the
machine's stability. Travel with the load low to the
ground. Travel slowly and with caution over rough,
muddy or loose surfaces.
5-1-3-2
1 Lower/raise the shovel to approximately 300mm
(12in) above the ground.
Keep the shovel in this position when you:
a Travel with a full shovel.
b Reverse up a slope.
c Travel across a slope.
Note: If you drive or turn the machine with the loader arm
in the raised position, the stability of the machine is
decreased.
2 Operate the control to fully 'crowd' the shovel.
3 Start the ACCS (option).
A351580-2
Fig 48.
Automatic Carry Control System - (if
fitted)
The Automatic Carry Control System (ACCS) is a
hydraulic suspension system that is designed to supply a
"cushion" effect for the loader arm lift rams, to give a
smoother ride when you travel on rough terrain. The
system is effective in all load conditions, from a full payload
to an empty shovel.
The system operates above 7kph (4.4mph) road speed.
When the system starts to operate, the loader arms may lift
slightly; the amount will depend on the load being carried.
A manual override stops the system if its not necessary
and because the accumulators keep their charge at all
times, there is no possibility of a loader arm hydraulic
collapse when the system is started.
To Next Page
Loading...
