Optional Attachments
Quickhitch Control
188 188
9811-3400-4
Disengage the Attachments
In this procedure to disengage the attachment, the
Quickhitch isolator switch is used to divert the hydraulic
power. If your machine has a power diverter lever
substitute this in the procedure for the Quickhitch Isolator
Switch.
1 Park the machine on hard, level ground, then lower
the attachment.
2 Apply the park brake and put the transmission in
neutral.
Note: If necessary, disconnect the hydraulic hoses.
K
Quick Release Couplings ( T 185).
3 Push and hold the Quickhitch isolator switch. (If
fitted).
4 Disengage the locking-pins A:
Servo-controls lever with an auxiliary lever: Push the
lever B until the locking-pins are retracted.
Servo-controls lever with an auxiliary button: Push
the button C until the locking-pins are retracted.
Multi-controls lever: Push the lever Z until the locking-
pins are retracted.
5 Release the Quickhitch isolator switch.
6 Disengage the attachment:
Servo-controls lever: Move the lever D to the right and
tilt the Quickhitch forward and lower the loader arms.
Multi-controls lever: Move the lever X forward and tilt
the Quickhitch forward and lower the loader arms.
7 When the pivot shaft E has disengaged from the
hooks F, reverse the machine clear.
801590-1
Fig 139.
T012730-3
Fig 140. Servo-controls lever with auxiliary lever
T013150-1
Fig 141. Servo-controls lever with auxiliary button
B
D
To Next Page
Loading...
