jcb 426 - Fire Extinguisher (if Fitted)

Operation
Safety Equipment
62 62
9811-3400-4
Fire Extinguisher (if fitted)
Location
The fire extinguisher is found inside the operator cab and
is held in position by a stowage bracket. Keep the fire
extinguisher in this position until you need to use it.
T033730-2
Fig 44.
Operation
T2-041_3
!MWARNING
Do not use the fire extinguisher in a confined space.
Make sure that the area is well ventilated during and
after using the fire extinguisher.
4-2-3-1
!MWARNING
After any use, the extinguisher should be replaced or
serviced.
4-2-3-2
Make sure that you understand how to use the fire
extinguisher. If necessary, refer to the instructions found
on the fire extinguisher.
Only try to extinguish a fire if the circumstances permit and
your safety is not endangered. If necessary, contact your
nearest fire department.
Using the fire extinguisher:
1 If the circumstances permit and your safety is not
endangered, move the machine to a safe place to
prevent the fire from spreading.
2 Remove extinguisher from its stowage bracket.
3 Remove safety pin A.
4 Aim directly at the fire from an upwind position, if
possible.
5 Squeeze trigger B to operate the extinguisher,
release the trigger to stop the flow.
S170520-3
Fig 45.
The fire extinguisher should be inspected daily. Refer to
Routine Maintenance, Fire Extinguisher (if fitted).