Operation
Operating Levers
60 60
9811-3400-4
Auxiliary Controls
!MWARNING
Before operating the Auxiliary control system make
sure that you are aware of all WARNINGS and
CAUTIONS that apply to the attachment you are using.
Also make sure you have fitted the attachment
correctly. (See OPTIONAL ATTACHMENT section).
5-2-2-6
!MCAUTION
If you have an optional attachment which is not
covered in this manual, do not fit it or use it until you
have obtained, read and understood the attachment
operating information.
2-4-1-1
All machines are supplied as standard with one auxiliary
service. A second auxiliary service can be installed as an
option.
The first auxiliary service is operated either:
– Mechanically by an auxiliary lever K
Servo-Control
Lever with Auxiliary Lever ( T 58)
– Or electrically by the auxiliary buttons on the loader
arm servo-control lever K
Servo-Control Lever with
Auxiliary Buttons ( T 59).
If the machine has a second auxiliary service, set the
auxiliary (AUX) switch to the auxiliary 2 position to divert
the hydraulic power to this function. K
Console
Switches ( T 42).
Dependant on which auxiliary service is selected, the
auxiliary buttons, or the auxiliary lever can operate the:
– Quickhitch locking-pins (first auxiliary service)
– Attachment, (second auxiliary service).
Note: On machines with a power diverter lever, the lever
must be in the horizontal position before the auxiliary
service can be used to operate an attachment. In the
horizontal position the Quickhitch locking-pins are in a
locked position. For more information on the power
diverter lever, refer to Attachments, Quickhitch Control.
To Next Page
Loading...
