Operation
Drive Controls, Switches and Instruments
42 42
9811-3400-4
Switches
General
806610-7
Fig 27.
Transmission Kickdown Switch
P4-2004
Press the button on the end of the left column lever, top
button on loader servo lever or button on top of the left
multi lever to operate the transmission kickdown.
When the kickdown switch is pressed once the system
shifts to the next lowest gear (dependant on road speed)
and autoshifts up and down but only as high as the gear
selected after the button was pressed. If button is pressed
again, reverts to autoshift.
When the kickdown switch is pressed twice (double press)
the system shifts to next lowest gear (dependant on road
speed) the system will shift through the gears in sequence
to 1st gear if required. If button is pressed once, reverts to
autoshift.
Transmission Dump Switch
T2-014
You do not need to depress the switch when changing
gear. The dump switch can be used to momentarily dump
the transmission pressure to improve the hydraulic
performance and reduce engine load.
Console Switches
Introduction
SW-001_2
The installed switches and their positions can change
according to the specification of the machine.
Each switch has a graphic symbol A to show the function
of the switch. Before you operate a switch, make sure that
you understand its function.
The rocker switches have two or three positions (as
shown).
If the switch has a backlight, then the graphic symbol A
comes on when the ignition switch or side lights are in the
ON position.
The light bar B comes on to show that the switch function
is active.
T042100-1
Fig 28.
A1 Transmission Kickdown Switch: Multi-Control
Lever
A2 Transmission Dump Switch: Mulit-Control Lever
B1 Transmission Kickdown Switch: Servo-Control
Lever
B2 Transmission Dump Switch: Servo-Control Lever
To Next Page
Loading...
