jcb 426 - Page 55

Operation
Drive Controls, Switches and Instruments
43 43
9811-3400-4
Left Console Switches Right Console Switches
Quickhitch Locking Pin Isolator (if fitted)
802990-1
Two position rocker switch (spring-
loaded). The switch functions operate
when the starter switch is in the ON
position.
Position 1: ON
Position 2: OFF (Push and hold while you
move the locking pins)
Before you operate this switch, refer to Quickhitch
Control (Attachments Section).
Transmission Dump Enable
339770-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: OFF (Backlight OFF).
Position 2: ON (Backlight ON).
In the transmission dump enable mode, the transmission
will `dump' each time the brake pedal is firmly pushed.
Transmission Mode
A347030-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: Manual Mode (Backlight
OFF).
Position 2: Auto Mode (Backlight ON).
Before you operate this switch, refer to Drive Controls,
Transmission.
Automatic Carry Control System (if fitted)
A339660-2
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: OFF (Backlight OFF).
Position 2: ON (Backlight ON).
Before you operate the switch, refer to Preparing the
Machine for Travel.
Rear Window Wiper (if fitted)
340070-1
Three position rocker switch. The switch
functions operate when the starter switch
is in the ON position.
Position 1: OFF
Position 3: ON
Position 2: Washer ON (if fitted)
Note: The wiper will self-park when switched off.
Rear Fog Light (if fitted)
340051-1
Two position rocker switch. The switch
functions operate when the starter switch
is in the ON position.
Position 1: OFF
Position 2: ON
Side Lights and Headlights
340151-1
Three position rocker switch with
backlight. The switch functions operate
when the starter switch is in the ON and
OFF positions.
Position 1: OFF (Backlight OFF)
Position 3: Side Lights ON (Backlight ON)
Position 2 (starter switch in the ON
position): Headlights ON (Backlight ON)
Position 2 (starter switch in the OFF
position): Side Lights ON (Backlight ON)
Machines without headlights or side lights are designed
for site use. You may be breaking local laws if you travel
on the road without headlights or side lights.
Hazard Warning Lights
339861-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON and OFF
positions.
Position 1: OFF (Backlight OFF).
Position 2: ON (Backlight ON). A light on
the instrument panel flashes with the
outside lights.