Operation
Drive Controls, Switches and Instruments
44 44
9811-3400-4
Auxiliary Hydraulic Circuit Changeover (if fitted)
A339690-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: AUX I
Position 2: AUX II
The switch energises a solenoid valve, which diverts the
hydraulic pressure from the default output connections
(AUX I) to the secondary output connections (AUX II).
Emergency Steer System (Engine Stopped)
764940-1
Two position rocker switch, when the
switch is released it automatically returns
to the OFF position. The switch functions
operate when the engine is stopped and
the starter switch is in the ON position.
Position 1: OFF
Position 2: ON
Before you operate this switch, refer to Moving a
Disabled Machine.
Shovel/Forks Pre-Set Angle Select (if fitted)
766710-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: Operate the shovel re-set
proximity-switch (Backlight OFF).
Position 2: Operate the forks re-set
proximity-switch (Backlight ON).
Before you operate the switch, refer to Working with the
Machine, Machine Adjustments.
Joystick Isolation (if fitted)
A340000-1
Two position rocker switch with backlight.
The switch functions operate when the
starter switch is in the ON position.
Position 1: OFF (Backlight OFF)
Position 2: ON (Backlight ON)
Before you operate the switch, refer to Control Lever
Locks (if fitted).
Cigar Lighter
A339760-1
Push the knob until it latches, do not hold
the knob in the pushed position. The knob
releases when its ready to be used.
Note: The cigar lighter must not be used for any other
purpose than that for which its intended.
Note: If a 12/24 Volt converter is installed, the lighter
socket can be used as a 12 Volt auxiliary power socket.
To Next Page
Loading...
