Routine Maintenance
Prepare the Machine for Maintenance
115 115
9811-3400-4
How to Make the Machine Safe (Loader
Arm Lowered)
P4-3016
1 If necessary, empty the shovel.
2 Make sure that the machine is parked correctly in the
straight-ahead position on hard, level ground. Refer
to Stopping and Parking the Machine (Operation
Section).
3 Lower the loader arm.
4 Put the attachment flat on the ground.
5 Remove the starter key.
6 Put chocks on both sides of all the wheels.
7 Remove the battery isolation key. Refer to Battery
Isolation Switch.
8 Install the articulation lock. Refer to Articulation
Lock (Operation Section).
9 Operate the controls to release the residual pressure.
10 If you are working on an area that you can not reach
when standing on the ground, you must use a
suitable, safe work-platform.
How to Make the Machine Safe (Loader
Arms Raised)
!MWARNING
Raised Equipment
Never walk or work under raised equipment unless it
is supported by a mechanical device. Equipment
which is supported only by a hydraulic device can
drop and injure you if the hydraulic system fails or if
the control is operated (even with the engine stopped).
Make sure that no-one goes near the machine while
you install or remove the mechanical device.
13-2-3-7_3
If you must lift the loader arms to get access to do a
maintenance procedure, you must install a suitable safety
mechanism. Refer to Safety Mechanism.
To Next Page
Loading...
