jcb 426 - Fuses

Routine Maintenance
Electrical System
142 142
9811-3400-4
Fuses
Introduction
!MCAUTION
Fuses
Always replace fuses with ones of correct ampere
rating to avoid electrical system damage.
8-3-3-5
The electrical circuits are protected by fuses A. The fuses
are located in a fuse box (shown with the cover removed)
behind the operators seat.
If a fuse breaks, find the cause and correct the fault before
a new fuse is installed.
To get access to the fuses:
1 Make the machine safe with the loader arms lowered.
Refer to Prepare the Machine for Maintenance.
2 Remove the cover (not shown).
T033790-2
Fig 88.
Note: The primary fuses are located in the engine
compartment. K Primary Fuses ( T 142).
Primary Fuses
The primary fuses A are located in two fuse boxes, which
are mounted at the right side of the battery bay inside the
rear grille.
If a fuse breaks, find the cause and correct the fault before
a new fuse is installed.
To get access to the fuses:
1 Make the machine safe with the loader arms lowered.
Refer to Prepare the Machine for Maintenance.
2 Open the rear grille. K
Rear Grille ( T 131).
T033780-1
Fig 89.