Routine Maintenance
Greasing
127 127
9811-3400-4
Automatic Greasing System (if fitted)
P4-3004
Introduction
The following points are greased by the automatic
greasing system (when fitted):
– Shovel Pivot Pins
– Loader Arm Pivot Points
– Centre Pivot and Steering Rams
Note: All other grease points must continue to be greased
as per the Service Schedules
When the ignition is ON, the greasing system performs all
operations automatically.
When switched on, the system will default to Normal Duty
Mode. For normal operation, this is the required mode.
When working in arduous conditions, Heavy Duty Mode
should be selected. K
System Controls ( T 127)
System Controls
C086280
Fig 72.
A Low Level Lamp (Yellow)
Reservoir requires replenishing.
B Error Lamp (Red)
System not operating due to insufficient grease.
C Light Duty Greasing Mode (Green)
Long interval between grease cycles.
D Normal Duty Greasing Mode (Green)
Standard interval between grease cycles.
E Heavy Duty Greasing Cycle (Green)
Short interval between grease cycles.
F Greasing Mode Selection Switch
Press the mode switch repeatedly until the desired
mode lamp (C, D or E) illuminates.
GREASING
MODE
Automatic
Greasing
System
TWIN
A
B
C
D
E
F
To Next Page
Loading...
