Routine Maintenance
Transmission
165 165
9811-3400-4
Changing the Oil and Filter
!MWARNING
Make the machine safe before working underneath it.
Park the machine on level ground, lower the
attachments to the ground. Apply the park brake, put
the transmission in neutral and stop the engine. Block
both sides of all four wheels.
Disconnect the battery, to prevent the engine being
started while you are beneath the machine.
GEN-4-1_1
1 Make the machine safe with the loader arm lowered.
Refer to Prepare the Machine for Maintenance.
2 Place a suitable container beneath the transmission.
(To catch the oil).
3 Remove the dipstick A. Refer to Checking the Oil
Level (Engine Running).
4 Remove the drain plug B.
5 Drain the oil. Clean and refit drain plug B.
6 Unscrew and discard old filter C. Clean the mounting
face and lubricate the seal on the new filter with clean
torque converter fluid.
7 Fit the new filter C hand tight only.
8 Fill the system with new oil at dipstick/filler point A.
Note: Do not fill past the top mark on the dipstick.
795550-1
Fig 122.
To Next Page
Loading...
