Operation
Working with the Machine
80 80
9811-3400-4
ZX Machines
1 Park the machine on hard, level ground. Refer to
Stopping and Parking the Machine.
2 Set the shovel to the angle required, with the shovel
on the ground.
3 Loosen the bolts F, then adjust the bar D, so that its
end is aligned with the proximity-switch E.
4 Tighten the bolts F.
5 Make sure that proximity-switch operates
automatically at the correct position. If necessary,
adjust the position of the proximity-switch again:
a Operate the control lever to lift the loader arms
sufficiently for the shovel to clear the ground when
its dumped.
b Fully dump the shovel.
c Crowd the shovel. The shovel should stop at the
pre-set angle.
Note: The detent position is only selectable when the
proximity switch is out of range of the sensor bar.
S264480-1
Fig 54.
To Next Page
Loading...
