Operation
Refuelling the Machine
86 86
9811-3400-4
!MCAUTION
Spilt fuel may cause skidding and therefore accidents.
Clean any spilt fuel immediately.
Do not use fuel to clean the machine.
When filling with fuel, choose a well aired and
ventilated area.
INT-2-2-12
At the end of every working day, fill the tank with the correct
type of fuel. This will prevent overnight condensation from
developing in the fuel.
1 Park the machine on hard, level ground. Refer to
Stopping and Parking the Machine.
2 Open the applicable side engine cover. Refer to
Routine Maintenance, Engine Covers.
3 Remove the filler cap. Refer to Introduction,
Component Locations.
The filler cap has a side-mounted barrel lock that is
operated by the ignition/door key. When the key is
removed, the cap will turn on the filler neck. To
remove the cap from the filler neck, put the key in the
lock and unlock the cap.
4 Fill the tank with the correct fuel. Refer to Routine
Maintenance, Fluid, Lubricants and Capacities.
5 Install and lock the filler cap.
6 Close and lock the engine cover.
To Next Page
Loading...
