189
MANUAL STARTER
ASSEMBLY
10
Remove nut and pulley retainer from mandrel and
remove starter assembly.
Install spindle, screw, and locknut. Tighten locknut
120 to 144 in. lbs. (14 to 16 N·m).
Examine lockout parts. Replace any worn or dam-
aged parts.
Install pawl, linkage, and retaining ring (sharp
edge up).
Check the operation of the pawl. The pawl should
extend when the starter rope is pulled and retract
when the starter rope rewinds.
Install screw into cam. Install plunger, spring, tap-
pet, and cam with retaining pin.
46717
46716
35054
To Next Page
Loading...