3 – 31
……Degaussing DEGAUSS …………………………………………
Since this radar equipment employs a color CRT, color slip-outs may be caused due to change
in the magnetism of the hull structure or the earth magnetism. When turning on the power, the
CRT is automatically degaussed. However, color slip-outs may be caused due to
magnetization during radar operation. In this case, it is necessary to degauss the CRT in the
following procedures:
1 Press .
The Main Menu will appear.
2 Press .
9. will be selected and the CRT will be
forcedly degaussed.
If it is insufficient by one time of degaussing, press
again after about 30 seconds.
1 Press .
The Main Menu will be closed.
……Radar Interference Rejection IR …………………………………
1 Press .
The Main Menu will appear.
2 Press .
“ON” in “1.IR” will be set.
Then, the mark at the lower left of the radar display will be shown and the radar
interference rejector is turned on.
To Next Page
Loading...
Need help?
General
