JRC JMA-9822-6XA User Manual

3 – 72
3
3.4 BASIC OPERATIONS
.
..
……FUNCTION………………………………………………………………
FUNCTION is a function of setting the process suited for each condition during navigation to
enhance the target detectability performance.
Setting items: the following modes can be switched over:
FUNC1: Effective in observing the echoes on short ranges.
FUNC2: Effective in observing the echoes on long ranges.
FUNC3: Effective in observing the echoes in rough weathers.
FUNC4: Set by service personnel. The initial setting is the same as FUNC1.
FUNC5: Set by service personnel. The initial setting is the same as FUNC1.
1 Press .
The Main Menu will appear.
2 Press .
will be selected and the pull-down menu will
appear.
3 Select a desired process setting item from the ten-key.
The process setting item will be changed and the current setting
state will appear at the lower right of the radar display.
4 For changing the setting item, open the pull-down
menu in step 2 above again and select a desired
process setting item.
1 Press .
The Main Menu will be closed.
1 Execute the procedures to function up to step 2.
will be selected and the pull-down menu will appear.
2 Press .
will be set and “FUNC ” will appear at the lower right of the radar
display.
OFF1. FUNC OFF
1
4.FUNCTION
Cancellation
0
Exit
4.FUNCTION
4
MENU
Procedures
MAIN MENU
0.
EXIT
2.TGT ENH
1.IR
3.PROCESS
4.FUNCTION
2. PROC1
OFF ON
OFF ON
7.
DATA OFF
8.
SUB1 MENU
9.
DEGAUSS
5.EBL1
CENTER OFFSET
6.EBL2
CENTER OFFSET
1. FUNC OFF
1. FUNC OFF
2. FUNC1
3. FUNC2
4. FUNC3
5. FUNC4
6. FUNC5

JRC JMA-9822-6XA Specifications

General

Brand	JRC
Model	JMA-9822-6XA
Category	Marine Radar
Language	English