– iii –
●
Cautions to be Used during Operation
●
Do not touch the insides of the scanner, transmitter-
receiver and display unit.
Touching any high voltage area, you will get an electric shock. For maintenance,
inspection and adjustment of internal parts of these equipment, consult with our
sales office or distributor in your district.
Since the scanner radiator rotates, do not approach it.
The scanner may start rotating suddenly, and consequently any person may be
struck and be injured. We recommend you to install the scanner radiator on the
roof of the wheel house, flying bridge, trestle, radar mast or any other high position
so that no person can approach it. When servicing the scanner, set the scanner
safety switch to the “OFF” position.
SCANNER RADIATION HAZARD
Never look up the antenna from which radiation is being
output from a distance less than the following.
Injury may result from exposure to radiation produced by the antenna (particularly
effects to the eyes) at a distance from the central front face of the antenna less than:
0.6 meter for NKE-1059/1052 (Radiation power density of 10 W/m
2
)
1.1 meter for NKE-1079/1075 (Radiation power density of 10 W/m
2
)
25 cm for NKE-1079/1075 (Radiation power density of 100 W/m
2
)
Install the scanner at any place higher than any person.
If being exposed directly to electric wave at close range, you may suffer adverse
influence.
When approaching the scanner for maintenance or
inspection, set the power switch of the display unit to the
“OFF” or “STBY” position.
If being exposed directly to electric wave to close range, you may suffer adverse
influence.
To Next Page
Loading...
Need help?
General
