3 – 3
1 Check that the ship’s mains are turned on.
2 Press .
The warm-up time will appear.
3 Press .
The radar starts transmission and the scanner starts rotating.
The STANDBY changes to TRANSMIT on the display.
Even if the [TX/STBY] switch is pressed before STANDBY is displayed, the radar does not
start transmission.
The way of operation to cancel preheat time at the emergency.
Push and hold key for about 10 seconds, and push the , ,
, , keys, the preheat time is canceled and become to ST-BY.
But there is a possibility that the degradation of the magnetron, use only in emergency.
To Next Page
Loading...
