JUMO TYA 202 - Typographical Conventions; Warning Signs

1 Introduction
8 2011-07-01/00561073 [SCR Power Controller TYA202]
1.2 Typographical conventions
1.2.1 Warning signs
Caution
Caution
ESD
Dangerous
voltage
Hot
surface,
fire hazard/
danger of burns
E
When accessing the inner parts of the device and returning device modules,
assemblies or components, please observe the regulations as per EN 61340-
5-1 and EN 61340-5-2 "Protection of electronic devices from electrostatic
phenomena". Only use ESD packaging for transport.
Please note that we cannot accept any liability for damage caused by ESD
(electrostatic discharge).
ESD=Electro Static Discharge
V
This symbol is used if there is a risk of injury to persons if the
instructions are ignored or not followed correctly.
A
This symbol is used if there is a risk of damage to equipment or
data if the instructions are ignored or not followed correctly.
E
This symbol is used where special care is required when handling
components susceptible to damage through electrostatic
discharge.
This symbol indicates dangerous voltage that will cause electric
shock if you come into contact with live components.
This symbol indicates the presence of a hot surface that can cause
burns if touched.
Do not install any heat sensitive components and devices close to
the power controller.