JUMO TYA 202 - Page 6

4 2011-07-01/00561073 [Thyristor Leistungssteller TYA202]
Content
end value ......................................................................................................................... 61
5.1.9 RS422/485 .......................................................................................................... 61
Baud rate ......................................................................................................................... 61
Data format ...................................................................................................................... 61
Device address ................................................................................................................ 61
Min. response time .......................................................................................................... 61
5.1.10 PROFIBUS-DP .................................................................................................... 62
Device address ................................................................................................................ 62
Data format ...................................................................................................................... 62
5.1.11 Changing codes ................................................................................................. 62
Code Manual mode ......................................................................................................... 62
Code User level................................................................................................................ 62
Code Config.level ............................................................................................................ 62
5.2 Configuration example ............................................................................ 63
6 Special device functions...........................................................65
6.1 Detection of load faults ........................................................................... 65
6.1.1 Teach-In .............................................................................................................. 67
6.2 Manual mode ............................................................................................ 68
6.2.1 Default set point value in manual mode .......................................................... 68
6.2.2 Configuring the teach-in (prerequisite for teach-in in manual mode) .......... 68
6.2.3 Performing teach-in in manual mode .............................................................. 69
6.3 Default set point value via potentiometer ............................................. 70
6.4 Dual energy management ....................................................................... 70
6.5 Cascade control ....................................................................................... 73
6.5.1 Closed control loop without cascade control ................................................. 73
6.5.2 Closed control loop with a subordinate control ............................................. 74
6.6 Resistance limitation (R control) ............................................................ 79
6.7 Current limiting ........................................................................................ 80
6.8 a start ........................................................................................................ 80
6.9 Monitoring of the supply voltage drop ................................................... 80
6.10 Firing-pulse inhibit ................................................................................... 81
7 Setup program...........................................................................83
7.1 Hardware and software, minimum requirements ................................. 83
7.1.1 Notes for Windows 2000/XP: ............................................................................ 83