Juniper EX9214

Table 40: Network Port LEDs on Line Cards in an EX9200 Switch—Link/Acvity LED
LED Color State and Descripon
Link/Acvity Green
• On steadily—The port and the link are acve, but
there is no link acvity.
• Blinking—The port and the link are acve, and there
is link acvity.
• O—The port is not acve.
Yellow (applicable only for
the 40-Gigabit Ethernet
ports on EX9200-6QS
line card)
On steadily—The link is disabled.
The Status LED in 10/100/1000BASE-T RJ-45 Ethernet network port indicates the status of one of the
three port parameters—administrave status, speed, and duplex mode status.
Table 41 on page 110 describes the Status LED.
Table 41: Network Port LEDs on Line Cards in an EX9200 Switch—Status LED
LED LCD Indicator State, Color, and Descripon
Status LED: ADM Indicates the administrave status (enabled or
disabled). The status indicators are:
• Green—Administrave status enabled.
• Yellow—The port is down.
• Unlit—Administrave status disabled.
LED: SPD Indicates the speed. The speed indicators are dierent
in the line cards.
• Unlit—10 Mbps
• Green—Blinking—100 Mbps
• Green—On steadily—1000 Mbps
110