Juniper EX9214

Table 58: Parts Required for Connecng an EX Series Switch to Earth Ground (Connued)
Switch Earthing
Terminal
Locaon
Grounding
Cable
Requirements
Grounding Lug
Specicaons
Screws and
Washers
Addional
Informaon
EX6210 Rear panel of
the chassis
(on lower le
side)
The grounding
cable must be
the same gauge
as the power
feed cables and
as permied by
the local code.
Panduit LCD2-14A-
Q or equivalent
—provided
• Two ¼ -20
x 0.5 in.
screws with
#¼” split-
washer
—provided
• Two #¼” at
washers—
provided
EX8208 Le side of
the chassis
6 AWG
(13.3 mm²),
minimum 90° C
wire, or as
permied by
the local code
Panduit LCD2-14A-
Q or equivalent
—provided
• Two ¼ -20
x 0.5 in.
screws with
#¼” split-
washer
—provided
• Two #¼” at
washers—
provided
169