Juniper EX9214 Hardware Guide

Table 58: Parts Required for Connecng an EX Series Switch to Earth Ground (Connued)
Switch Earthing
Terminal
Locaon
Grounding
Cable
Requirements
Grounding Lug
Specicaons
Screws and
Washers
Addional
Informaon
EX8216 Two earthing
terminals:
• Le side
of the
chassis
• Rear
panel of
the
chassis
NOTE: You
must use
only one of
the two
protecve
earthing
terminals.
2 AWG
(33.6 mm²),
minimum 90° C
wire, or as
permied by
the local code
Panduit LCD2-14A-
Q or equivalent
—provided
• Two ¼ -20 x
0.5 in.
screws with
#¼” split-
washer
—provided
• Two #¼” at
washers—
provided
EX9204,
EX9208,
and
EX9214
Rear panel of
the chassis
One 6 AWG
(13.3 mm²),
minimum 90° C
wire, or one
that complies
with the local
code
Thomas& Bes
LCN6-14 or
equivalent—
provided
• Two ¼ -20
x 0.5 in.
screws with
#¼” split-
washer—
provided
• Two #¼” at
washers—
provided
See Grounding
Cable and Lug
Specicaons for
EX9200 Switches.
170

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English