EasyManuals Logo

Juniper SRX100 Hardware Guide

Juniper SRX100
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
Electrical Safety Guidelines and Warnings
In Case of Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1. Use caution. Be aware of potentially hazardous conditions that could cause further
injury.
2. Disconnect power from the services gateway.
3. If possible, send another person to get medical aid. Otherwise, assess the
condition of the victim, then call for help.
General Electrical Safety Guidelines and Warnings
Install the services gateway in compliance with the following local, national, or
international electrical codes:
United StatesNational Fire Protection Association (NFPA 70), United States
National Electrical Code
CanadaCanadian Electrical Code, Part 1, CSA C22.1
Other countriesInternational Electromechanical Commission (IEC) 60364,
Part 1 through Part 7
Evaluated to the TN power system
Locate the emergency power-off switch for the room in which you are working
so that if an electrical accident occurs, you can quickly turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your
workspace.
Never assume that power is disconnected from a circuit. Always check the circuit
before starting to work.
Carefully look for possible hazards in your work area, such as moist floors,
ungrounded power extension cords, and missing safety grounds.
Operate the services gateway within marked electrical ratings and product usage
instructions.
For the services gateway and peripheral equipment to function safely and
correctly, use the cables and connectors specified for the attached peripheral
equipment, and make certain they are in good condition.
Related Topics SRX100 Services Gateway Electrical and Power Requirements on page 23
SRX100 Services Gateway Maintenance and Operational Safety Guidelines and
Warnings on page 105
SRX100 Services Gateway Agency Approvals on page 111
Grounding the SRX100 Services Gateway on page 47
110 SRX100 Services Gateway Electrical Safety Guidelines and Warnings
SRX100 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX100 and is the answer not in the manual?

Juniper SRX100 Specifications

General IconGeneral
Routing protocolsBGP, IS-IS, MPLS, OSPF
Switching protocolsVLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocolsIPv4, IPv6, CLNS
Firewall securityYes
Security algorithms3DES, DES
Authentication methodRADIUS, RSA SecureID, LDAP
VPN supportIPsec VPN
Data transfer rate0.1 Gbit/s
Input voltage100 - 240 V
Input frequency50/60 Hz
Heat dissipation35 BTU/h
Power requirements100-240, 50/60
Power over Ethernet (PoE)No
Power consumption (typical)30 W
SafetyUL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
CertificationFCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting typeRack mounting
Internal memory1024 MB
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight1100 g
Dimensions (WxDxH)216 x 147 x 36 mm

Related product manuals