EasyManuals Logo

Juniper SRX100 Hardware Guide

Juniper SRX100
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Chapter 10
SRX100 Services Gateway Memory
Upgrade
This chapter includes the following section:
Upgrading the SRX100 Services Gateway Low Memory Version to a High Memory
Version on page 51
Upgrading the SRX100 Services Gateway Low Memory Version to a High Memory
Version
Based on your requirements, you can upgrade from an SRX100 Services Gateway
Low Memory version to a High Memory version through a license key. You need not
order a separate High Memory device.
The double-data-rate (DDR) memory allocation in the SRX100 Services Gateway is
as follows:
SRX100 Services Gateway High Memory - 1 GB
SRX100 Services Gateway Low Memory - 512 MB
All SRX100 Services Gateways have a built-in DDR memory of 1 GB. The SRX100
Services Gateway Low Memory devices can utilize a maximum of 512 MB of DDR
memory. To utilize 1 GB of DDR memory, you must upgrade your device to an
SRX100 Services Gateway High Memory version by installing the memory upgrade
license. You can install the memory license using the CLI configuration editor. For
more information, see the JUNOS Software Administration Guide.
NOTE: When you install the memory upgrade license on an SRX100 Services Gateway
Low Memory device, the device reboots automatically. When the device is active
again, it will function as a High Memory device.
NOTE: The memory upgrade license is a perpetual license. You can activate this
feature on the device by directly entering the licence key (provided by the licensing
management system) in the CLI.
Upgrading the SRX100 Services Gateway Low Memory Version to a High Memory Version 51

Table of Contents

Other manuals for Juniper SRX100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX100 and is the answer not in the manual?

Juniper SRX100 Specifications

General IconGeneral
Routing protocolsBGP, IS-IS, MPLS, OSPF
Switching protocolsVLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocolsIPv4, IPv6, CLNS
Firewall securityYes
Security algorithms3DES, DES
Authentication methodRADIUS, RSA SecureID, LDAP
VPN supportIPsec VPN
Data transfer rate0.1 Gbit/s
Input voltage100 - 240 V
Input frequency50/60 Hz
Heat dissipation35 BTU/h
Power requirements100-240, 50/60
Power over Ethernet (PoE)No
Power consumption (typical)30 W
SafetyUL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
CertificationFCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting typeRack mounting
Internal memory1024 MB
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight1100 g
Dimensions (WxDxH)216 x 147 x 36 mm

Related product manuals