Juniper SRX100 Hardware Guide

Chapter 3
Preparing the Site for SRX100 Services
Gateway Installation
This chapter provides a checklist to help you prepare your site for installation of the
SRX100 Services Gateway. Read this section to make sure that your site has the
proper operating environment and equipment.
This chapter includes the following sections:
■ Site Preparation Checklist for the SRX100 Services Gateway on page 17
■ General Site Guidelines for Installing the SRX100 Services Gateway on page 19
■ SRX100 Services Gateway Cabinet Requirements on page 20
■ SRX100 Services Gateway Rack Requirements on page 21
■ Clearance Requirements for Airflow and Hardware Maintenance of the SRX100
Services Gateway on page 22
■ SRX100 Services Gateway Electrical and Power Requirements on page 23
Site Preparation Checklist for the SRX100 Services Gateway
The checklist in Table 10 on page 17 summarizes the tasks you need to perform
when preparing a site for installing the SRX100 Services Gateway.
Table 10: Site Preparation Checklist for Services Gateway Installation
NotesDatePerformed ByAdditional
Information
Item or Task
Environment
“SRX100 Services
Gateway
Specifications” on
page 5
Verify that environmental
factors such as temperature and
humidity do not exceed device
tolerances.
Power
Site Preparation Checklist for the SRX100 Services Gateway ■ 17

Juniper SRX100 Specifications

General

Routing protocols	BGP, IS-IS, MPLS, OSPF
Switching protocols	VLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocols	IPv4, IPv6, CLNS
Firewall security	Yes
Security algorithms	3DES, DES
Authentication method	RADIUS, RSA SecureID, LDAP
VPN support	IPsec VPN
Data transfer rate	0.1 Gbit/s
Input voltage	100 - 240 V
Input frequency	50/60 Hz
Heat dissipation	35 BTU/h
Power requirements	100-240, 50/60
Power over Ethernet (PoE)	No
Power consumption (typical)	30 W
Safety	UL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
Certification	FCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting type	Rack mounting
Internal memory	1024 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	1100 g
Dimensions (WxDxH)	216 x 147 x 36 mm