Juniper SRX100 - Displaying Basic Connectivity Configurations for the SRX100 Services Gateway

■ Connecting an SRX100 Services Gateway to the CLI Remotely on page 64
■ Displaying Basic Connectivity Configurations for the SRX100 Services Gateway
on page 73
Displaying Basic Connectivity Configurations for the SRX100 Services Gateway
To verify that the services gateway has the settings you configured, you should display
the basic connectivity configurations. Because the basic connectivity settings appear
in different places in the configuration hierarchy, displaying the entire configuration
at once makes viewing the settings easier.
To display the basic connectivity settings, select Configure> CLI tools> CLI Viewer.
Alternatively, from configuration mode in the CLI, enter the show command. Review
the following sample output. Your output will display the values you set.
[edit]
user@host# show
system {
host-name devicea;
domain-name lab.device.net;
domain-search [ lab.device.net device.net ];
backup-device 192.168.2.44;
time-zone America/Los_Angeles;
root-authentication {
ssh-rsa "ssh-rsa AAAAB3Nza...D9Y2gXF9ac==root@devicea.lab.device.net";
}
name-server {
10.148.2.32;
}
services {
}
ntp {
server 10.148.2.21;
}
}
interfaces {
fe-0/0/0 {
unit 0 {
family inet {
address 192.168.1.1/24;
}
}
}
lo0 {
unit 0 {
family inet {
address 172.16.1.24/32;
}
}
}
}
Displaying Basic Connectivity Configurations for the SRX100 Services Gateway ■ 73
Chapter 12: Establishing Basic Connectivity for the SRX100 Services Gateway