Juniper SRX100 Hardware Guide

Chapter 13
Maintaining the SRX100 Services
Gateway Hardware Components
This chapter describes how to maintain the hardware components of the SRX100
Services Gateway. This chapter includes the following section:
■ Maintaining the SRX100 Services Gateway Hardware Components on page 77
Maintaining the SRX100 Services Gateway Hardware Components
Table 27 on page 77 describes the common tasks for maintaining the hardware
components of the services gateway.
Table 27: Maintenance Procedures for the SRX100 Services Gateway Hardware Components
DescriptionMaintenance Procedures
For optimum performance of the services gateway, you should regularly perform the following
preventive maintenance procedures :
■
Inspect the installation site for moisture, loose wires or cables, and excessive dust.
■
Make sure that airflow is unobstructed around the device and into the air intake vents.
Routine maintenance
To maintain the power supply on the services gateway:
■
Make sure that the power and grounding cables are arranged so that they do not obstruct
access to other device components.
■
Periodically inspect the site to ensure that the grounding and power cables connected to
the device are securely in place and that there is no moisture accumulating near the device.
CAUTION: We recommend using a surge protector for the power connection.
Maintaining the power
supply
Related Topics ■ Site Preparation Checklist for the SRX100 Services Gateway on page 17
■ Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 79
■ Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
■ Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
■ Monitoring the SRX100 Services Gateway Power System on page 84
Maintaining the SRX100 Services Gateway Hardware Components ■ 77

Juniper SRX100 Specifications

General

Routing protocols	BGP, IS-IS, MPLS, OSPF
Switching protocols	VLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocols	IPv4, IPv6, CLNS
Firewall security	Yes
Security algorithms	3DES, DES
Authentication method	RADIUS, RSA SecureID, LDAP
VPN support	IPsec VPN
Data transfer rate	0.1 Gbit/s
Input voltage	100 - 240 V
Input frequency	50/60 Hz
Heat dissipation	35 BTU/h
Power requirements	100-240, 50/60
Power over Ethernet (PoE)	No
Power consumption (typical)	30 W
Safety	UL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
Certification	FCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting type	Rack mounting
Internal memory	1024 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	1100 g
Dimensions (WxDxH)	216 x 147 x 36 mm