EasyManuals Logo

Juniper SRX100 Hardware Guide

Juniper SRX100
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
When the services gateway is powered on for the first time, the system looks for a
DHCP server. If it does not find one, the system assigns an IP address within the
192.168.1.0/24 subnetwork to any devices connected to the system.
To connect to the J-Web interface through port fe0/0/0 on the services gateway,
see Figure 13 on page 61.
Figure 13: Connecting to the Ethernet Port on an SRX100 Services Gateway
1. From the management device you use to access the J-Web interface (such as a
PC or a laptop), verify that the address of the port you connect to is set to one
of the following values:
Ethernet address on the 192.168.1/24 subnetwork other than 192.168.1.1
Ethernet address from a DHCP server
2. Plug one end of the Ethernet cable into the Ethernet port on the management
device.
3. Connect the other end of the Ethernet cable to the built-in Fast Ethernet port on
the services gateway.
4.
Wait until the Status LED on the front panel turns solid green.
5. Turn on the power to the management device. The services gateway assigns an
IP address to the management device within the 192.168.1.0/24 subnetwork
if the services gateway is configured to use DHCP.
6. From the management device, open a Web browser and enter the IP address
192.168.1.1 in the address field. The J-Web Quick Configuration Set Up page
appears.
7. Configure basic settings for your services gateway.
Connecting an SRX100 Services Gateway to the J-Web Interface 61
Chapter 12: Establishing Basic Connectivity for the SRX100 Services Gateway

Table of Contents

Other manuals for Juniper SRX100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX100 and is the answer not in the manual?

Juniper SRX100 Specifications

General IconGeneral
Routing protocolsBGP, IS-IS, MPLS, OSPF
Switching protocolsVLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocolsIPv4, IPv6, CLNS
Firewall securityYes
Security algorithms3DES, DES
Authentication methodRADIUS, RSA SecureID, LDAP
VPN supportIPsec VPN
Data transfer rate0.1 Gbit/s
Input voltage100 - 240 V
Input frequency50/60 Hz
Heat dissipation35 BTU/h
Power requirements100-240, 50/60
Power over Ethernet (PoE)No
Power consumption (typical)30 W
SafetyUL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
CertificationFCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting typeRack mounting
Internal memory1024 MB
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight1100 g
Dimensions (WxDxH)216 x 147 x 36 mm

Related product manuals