Chapter 7
Preparing the SRX100 Services Gateway
for Installation
This chapter includes the following sections:
■ Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 35
■ Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 36
■ Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 37
Preparing the SRX100 Services Gateway for Rack-Mount Installation
You can mount an SRX100 Services Gateway in four-post (telco) racks, enclosed
cabinets, and open-frame racks.
NOTE: Center-mount racks are not supported.
Before mounting the SRX100 Services Gateway in a rack:
■ Verify that the installation site meets the requirements described in “Site
Preparation Checklist for the SRX100 Services Gateway” on page 17.
■ Verify that the racks or cabinets meet the specific requirements described in
“SRX100 Services Gateway Rack Requirements” on page 21.
■ Place the rack or cabinet in its permanent location, allowing adequate clearance
for airflow and maintenance, and secure it to the building structure. For more
information, see “Clearance Requirements for Airflow and Hardware Maintenance
of the SRX100 Services Gateway” on page 22.
■ Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX100 Services Gateway” on page 31.
■ Verify that you have the following parts available in your rack-mounting kit for
the SRX100 Services Gateway:
■ Rack-mount tray
■ Screws
Preparing the SRX100 Services Gateway for Rack-Mount Installation ■ 35
To Next Page
Loading...
