Preparing the SRX100 Services Gateway for Wall-Mount Installation
You can mount an SRX100 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Before mounting an SRX100 Services Gateway on a wall:
■ Verify that the site meets the requirements described in “Site Preparation
Checklist for the SRX100 Services Gateway” on page 17.
■ Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX100 Services Gateway” on page 31.
■ Verify that you have the following parts available in your wall-mounting kit for
the SRX100 Services Gateway:
■ Wall-mounting brackets
■ Screws
NOTE: The wall-mounting kit is not shipped with the device and must be ordered
separately.
Related Topics ■ Site Preparation Checklist for the SRX100 Services Gateway on page 17
■ Unpacking the SRX100 Services Gateway on page 31
■ Clearance Requirements for Airflow and Hardware Maintenance of the SRX100
Services Gateway on page 22
■ Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 35
■ Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 36
Preparing the SRX100 Services Gateway for Wall-Mount Installation ■ 37
Chapter 7: Preparing the SRX100 Services Gateway for Installation
To Next Page
