Juniper SRX100 - Chapter 5 Required Tools and Parts for Installing and Maintaining the SRX100; Required Tools and Parts for Installing and Maintaining the SRX100 Services Gateway

Chapter 5
Required Tools and Parts for Installing
and Maintaining the SRX100 Services
Gateway
This chapter includes the following section:
■ Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway on page 29
Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway
Table 15 on page 29 lists the tools and parts required to install and maintain the
SRX100 Services Gateway.
Table 15: Required Tools and Parts for Installing and Maintaining the SRX100 Services Gateway
Related TopicTools and PartsTask
“Unpacking the SRX100 Services
Gateway” on page 31
■
Phillips (+) screwdriver, number 2
■
1/2 in. (13 mm) open-end or socket
wrench to remove bracket bolts
from the shipping pallet
Unpacking the SRX100 Services Gateway
“Installing the SRX100 Services Gateway
in a Rack” on page 40
“Installing the SRX100 Services Gateway
on a Desk” on page 42
“Installing the SRX100 Services Gateway
on a Wall” on page 43
■
Phillips (+) screwdriver, number 2
■
Tie wrap
Installing the SRX100 Services Gateway
“Connecting the SRX100 Services
Gateway to the Power Supply” on page
45
Electrostatic discharge (ESD) grounding
wrist strap
Connecting the SRX100 Services
Gateway
“Grounding the SRX100 Services
Gateway” on page 47
Phillips (+) screwdrivers, numbers 1 and
2
Grounding the SRX100 Services Gateway
Required Tools and Parts for Installing and Maintaining the SRX100 Services Gateway ■ 29