Chapter 12
Establishing Basic Connectivity for the
SRX100 Services Gateway
This chapter includes the following sections:
■ SRX100 Services Gateway Basic Connectivity on page 55
■ Connecting to an SRX100 Services Gateway on page 60
■ Configuring Basic Connectivity Settings on the SRX100 Services
Gateway on page 67
SRX100 Services Gateway Basic Connectivity
This topic includes the following sections on connecting the SRX100 Services Gateway
to the network and establishing basic connectivity:
■ SRX100 Services Gateway Basic Connectivity Overview on page 55
■ SRX100 Services Gateway Basic Connectivity Settings on page 56
■ Built-In Ethernet Ports for the SRX100 Services Gateway on page 58
■ Management Access for the SRX100 Services Gateway on page 59
SRX100 Services Gateway Basic Connectivity Overview
The JUNOS Software is preinstalled on the services gateway. When the device is
powered on, it is ready to be configured.
If you are setting up a services gateway for the first time, you can use either J-Web
configuration editor or CLI configuration editor to configure basic connectivity.
If you are setting up many services gateways, autoinstallation can help automate the
configuration process.
Before you configure the services gateway for the first time, you should complete
the prerequisite tasks shown in Table 19 on page 56:
SRX100 Services Gateway Basic Connectivity ■ 55
To Next Page
Loading...
