Related Topics ■ Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
■ Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
■ Monitoring the SRX100 Services Gateway Power System on page 84
■ Maintaining the SRX100 Services Gateway Hardware Components on page 77
■ Using the Reset Config Button on the SRX100 Services Gateway on page 85
■ Juniper Networks Technical Assistance Center on page 87
Monitoring the SRX100 Services Gateway Components Using LEDs
Table 28 on page 81 describes the status of the LEDs on start up of the device.
Table 28: Services Gateway LED Status on Startup
DescriptionStateLED
Indicates that the device is starting up.AmberStatus LED
Indicates that the device is starting up for the first
time since no rescue configuration is set.
AmberAlarm LED
Indicates that the device is receiving normal power
supply.
GreenPower LED
Indicates that the device is not part of chassis
clustering set up.
OffHA LED
NOTE: Chassis clustering is not supported in this release.
The LEDs available on the services gateway display the status of various components.
Table 29 on page 82 describes the LEDs.
Monitoring the SRX100 Services Gateway Components Using LEDs ■ 81
Chapter 14: Monitoring the SRX100 Services Gateway
To Next Page
Loading...
