KCP Heavy Industries Co., Ltd. Safety Regulations
2 - 4
2.3 Designated use
The machine is designed exclusively for the delivery of concretes up to a bulk density of
2,400 kg/m3. Its operation must be restricted to pumping operations on construction sites.
The maximum concrete pressure must not exceed that specified on the rating plate or in
the checkbook.
You must also observe the specified Operating Instructions and comply with the conditions
and intervals for maintenance and inspection to operate the machine within the limits of its
designated use.
2.4 Safety regulation
2.4.1 General Safety Regulations
1) The operator of this equipment is required to have education and experience regarding
the operating instruction and relevant regulations for safe operation.
2) Replacing parts, operators are requested to use certified parts approved by KCP Heavy
Industries Co.,Ltd.
3) When it is necessary to uninstall or/and servicing hydraulic pipe, pre-existing pneumatic
pressure needs to be discharged before removing from the hydraulic fluid tank in order to
prevent the excessive leakage and accidents
4) It is strictly prohibited to access or climb the machinery other than equipment operator.
5) Safety-related components and parts should not be replaced nor eliminated.
6) Immediate repairing required when the machinery does not work properly just the way it
was operating before.
7) Electric and hydraulic systems and manual operation must be stated safely.
You must always be aware about this may cause a malfunction because Electric and
Hydraulic are controlled by remote controller
8) Construction site conditions ensuring visibility of work should be guaranteed if not extra
person must help for cooperation as assistant to visualize the site.
9) Lock status of outrigger must in place before driving or moving the vehicle.
10) Always, must be worn with a helmet, safety glasses and other personal protective
equipment anywhere, anytime at the construction site
To Next Page
Loading...