KCP Heavy Industries Co., Ltd. Operation
5-9
Restarting after Overheating
Should the pump have, nevertheless, been switched off because of overheating, you
should proceed as follows:
► Switch the pump off.
► Never switch the engine off, as the hydraulic fluid radiator must remain
in operation.
► Refresh the water in the water box.
► Wait until the hydraulic fluid has cooled if you are not able to find the fault
immediately.
► Once the red indicator lamp has extinguished, switch the pump back on and
continue
pumping slowly at reduced output.
► Determine the cause of the fluid overheating once pumping operations have
been completed and resolve the problems.
To Next Page
Loading...