SCPI command subsystems reference tables
Table 5-2 through Table 5-11 summarize the commands for each SCPI
subsystem. The following list includes the SCPI subsystem commands and
the table number where each command is summarized.
CALCulate command summary (Table 5-2)
DISPlay command summary (Table 5-3)
FORMat command summary (Table 5-4)
OUTPut command summary (Table 5-5)
ROUTe command summary (Table 5-6)
SENSe command summary (Table 5-7)
STATus command summary (Table 5-8)
SYSTem command summary (Table 5-9)
TRACe command summary (Table 5-10)
TRIGger command summary (Table 5-11)
UNIT command summary (Table 5-12)
General notes:
• Brackets ([ ]) are used to denote optional character sets. These optional
characters do not have to be included in the program message. Do not use
brackets in the program message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle
brackets in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument
operation. 1 or ON enables the operation and 0 or OFF disables the
operation.
• Upper case characters indicate the short-form version for each command
word.
• Default Parameter - Listed parameters are both the *RST and
:SYSTem:PRESet defaults, unless noted otherwise. Parameter notes are
located at the end of each table.
• SCPI - A checkmark (√) indicates that the command and its parameters are
SCPI confirmed. An unmarked command indicates that it is
non-SCPI. SCPI confirmed commands that use one or more non-SCPI
parameters are explained by notes.
SCPI Command Reference 5-7
To Next Page
Loading...
