Calculate subsystem
The commands in this subsystem are used to configure and control the
Calculate subsystems and are summarized in Table 5-2.
:CALCulate[1]
These commands are used to configure and control the MXB (polynomial)
and percent math calculations. Detailed information on math calculations is
provided in Section 2.
:FORMat <name>
CALCulate[1]:FORMat <name> Specify CALC1 format
Parameters <function> = NONE No calculations
MXB Polynomial math calculation
PERCent Percent math calculation
Query :FORMat? Query programmed math format
Description This command is used to specify the format for the CALC1 math
calculations. With NONE selected, no CALC1 calculation is performed.
With MXB or PERCent selected and enabled (see :STATe), the result of the
calculation is displayed. The calculated reading is refreshed every time the
instrument takes a reading.
:KMATh commands
:MMFactor <Nrf>
:CALCulate [1]:KMATh:MMFactor <NRf> Specify “m” factor
Parameter <NRf> = -100e6 to 100e6
Query :MMFactor? Query “m” factor
Description This command is used to define the “m” factor for the mx+b calculation.
:MBFactor <NRf>
:CALCulate [1]:KMATh:MBFactor <Nrf> Specify “b” factor
Parameter <NRf> = -100e6 to 100e6
Query :MBFactor? Query “b” factor
Description This command is used to define the “b” factor for the mx+b calculation.
5-22 SCPI Command Reference
To Next Page
Loading...
