Keithley 2016 - Output Subsystem

OUTPut subsystem
This subsystem is used to control the function generator outputs. These commands are
summarized in Table 5-5.
:OUTPut[:STATe] <b> Set the state of the output of the function
generator
Parameters <b> = 1 or ON Enables the generator
0 of OFF Disables the generator
Query :OUTPut? Query state of the generator
Description This command controls the state output of the function generator.
:OUTPut:FREQuency <NRf> Set the frequency of the output of the
function generator
Parameters <NRf> =10 to 20000 Hz Specify output frequency
Query :FREQuency? Query the output frequency
Description This command sets the frequency of the output of the function generator.
:OUTPut:IMPedance <name> Set the output impedance of the function
generator
Parameters OHM50 50Ω impedance
OHM600 600
Ω impedance
HIZ High impedance
Query :IMPedance? Query the impedance
Description This command controls the output impedance of the function generator.
:OUTPut:AMPLitude <NRf> Set the output amplitude of the function
generator
Parameters <NRf> = 0 to 9.5V RMS for HIZ Specify output voltage
0 to 4.75V RMS for OHM50 and OHM600
Query :AMPLitude? Query the amplitude
Description This command controls the output voltage of the function generator.
:OUTPut:CHANnel2[:SHAPe] <name> Set the shape of the output of the channel
2 output
Parameters ISINE Inverted sine
PULSE Pulse waveform
Query :CHANnel2? Query the shape
Description This command controls the shape of the function generator channel 2 output
waveform.
5-34 SCPI Command Reference