Keithley 2016 - Page 188

:COUNt <n>
[:SENSe[1]]:CURRent:AC:AVERage:COUNt <n> Specify filter count for ACI
[:SENSe[1]]:CURRent[:DC]:AVERage:COUNt <n> Specify filter for DCI
[:SENSe[1]]:VOLTage:AC:AVERage:COUNt <n> Specify filter count for ACV
[:SENSe[1]]:VOLTage[:DC]:AVERage:COUNt <n> Specify filter count for DCV
[:SENSe[1]]:RESistance:AVERage:COUNt <n> Specify filter count for Ω2
[:SENSe[1]]:FRESistance:AVERage:COUNt <n> Specify filter count for Ω4
[:SENSe[1]]:TEMPerature:AVERage:COUNt <n> Specify filter count for TEMP
[:SENSe[1]]:DISTortion:AVERage:COUNt <n> Specify filter count for distortion
Parameters <n> = 1 to 100 Specify filter count
DEFault 10
MINimum 1
MAXimum 100
Query :COUNt? Query filter count
:COUNt? DEFault Query the *RST default filter count
:COUNt? MINimum Query the lowest allowable filter count
:COUNt? MAXimum Query the largest allowable filter count
Description These commands are used to specify the filter count. In general, the filter
count is the number of readings that are acquired and stored in the filter
buffer for the averaging calculation. The larger the filter count, the more
filtering that is performed.
5-46 SCPI Command Reference