Keithley 2016 - Page 202

5-60 SCPI Command Reference
:ENABle <list>
:STATus:QUEue:ENABle <list> Enable messages for Error Queue
Parameter <list> = (numlist)
where numlist is a specified list of messages that you wish to enable for the
Error Queue.
Query :ENABle? Query list of enabled messages
Description On power-up, all error messages are enabled and will go into the Error Queue
as they occur. Status messages are not enabled and will not go into the queue.
This command is used to specify which messages you want enabled.
Messages not specified will be disabled and prevented from entering the
queue.
When this command is sent, all messages will first be disabled, then the
messages specified in the list will be enabled. Thus, the returned list
(:ENABle?) will contain all the enabled messages.
Messages are specified by numbers (see Appendix B). The following
examples show various forms for expressing a message numlist:
Numlist = -110 Single message.
-110, -140, -222 Messages separated by commas.
-110:-222 Range of messages (-110 through -222).
-110:-222, -230 Range entry and single entry separated by
a comma.
NOTE To disable all messages from entering the Error Queue, send the
following command:
:stat:que:enab ()
:DISable <list>
:STATus:QUEue:DISable <list> Disable messages for Error Queue
Parameter <list> = (numlist)
where numlist is a specified list of messages that you wish to disable for the
Error Queue.
Query :DISable? Query list of disabled messages
Description On power-up, all error messages are enabled and will go into the Error Queue
as they occur. Status messages are not enabled and will not go into the queue.
This command is used to specify which messages you want disabled.
Disabled messages are prevented from going into the Error Queue.
Messages are specified by numbers (see Appendix B). See :QUEue:ENABle
for examples to express a numlist.