Keithley 2016 - Page 265

R
Rack mount kits 1-5
Range 2-33, 3-2
Rate 3-6
READ? command 5-5
Reading hold (autosettle) 3-11
Rear panel summary 2-6
Recalling readings 3-17
Relative 3-5
Remote Operation 4-1
REN (remote enable) 4-12
Replacing fuse 2-9
Response message terminator (RMT) 4-33
Response messages 4-33
Response time 3-4
ROUTe subsystem 5-36
RS-232 4-3
RS-232 connections 4-6
RS-232 interface commands 5-66
RS-232 operation 4-4
S
Safety symbols and terms 1-3
Scan operations 3-21
Scanning examples 3-24
Scanning overview 3-21
Scanning trigger model additions 3-21
SCPI Command Reference 5-1
SCPI command subsystems reference
tables 5-7
SCPI commands D-11
SCPI Conformance Information E-1
SCPI Signal oriented measurement
commands 5-2
SDC (selective device clear) 4-14
Selecting an interface 4-2
Selecting baud rate 4-4
Selecting signal handshaking (flow control) 4-5
Selecting the primary address 4-10
Sending a response message 4-33
Sending and receiving data 4-4
[SENSe[1]] subsystem 5-37
Serial poll and SRQ 4-23
Service request enable register 4-22
Setting limit values 3-19
Setting line voltage and replacing fuse 2-9
Setting terminator 4-5
Shielding 2-18, 2-23
Short-form rules 4-30
Short-form versions 4-29
Single command messages 4-31
SPE, SPD (serial polling) 4-14
Specifications 1-3, A-2
Specs and Accessories A-1
Speed commands 5-39
Status and Error Messages B-1
Status and error messages 2-16
Status byte and service request (SRQ) 4-21
Status byte register 4-22
Status messages 2-16
Status structure 4-16
STATus subsystem 5-53
Stepping and scanning trigger model
additions 3-21
Storing readings 3-17
Storing readings in buffer C-6
subsystem 5-37
System operations 3-26
SYSTem subsystem 5-61
T
Taking readings using the
READ? command C-8
Testing diodes 2-33
Thermal EMFs 2-18
Thermocouple commands 5-48
Threshold resistance level 2-32
TRACe subsystem 5-67
Trigger level 2-24
Trigger model 3-8
Trigger model (GPIB operation) 4-24
Trigger model operation 4-25
Trigger operations 3-8
Trigger subsystem 5-69
Typical command sequences D-13
U
Unaddress commands D-10
Uniline commands D-9
UNIT subsystem 5-72
Universal multiline commands D-9
Using common commands and SCPI commands
in the same message 4-32
Using SHIFT-CONFIG to configure stepping
and scanning 3-23
V
Voltmeter complete 3-12
W
Warm-up time 2-15
Warranty information 1-3