Keysight 16860 Series Portable Logic Analyzer Service Guide 19
Preparing for Troubleshooting or Performance Testing 2
To apply power
1 Connect the supplied power cord to the instrument and to the power source.
This instrument autodetects the line voltage from 100 VAC to 240 VAC. It is equipped with a
three-wire power cable. When connected to an appropriate AC power outlet, this cable grounds
the instrument cabinet. The type of power cable plug shipped with the instrument depends on
the model ordered and the country of destination.
2 Turn on the power switch located on the front panel.
For first-time power up considerations and setup steps, refer to the Installation Guide that came
with your instrument. To get the most up-to-date installation guide:
• Go to www.keysight.com.
• Search for 16860 Series Logic Analyzers.
• Look under Technical Support and then Document Library.
To Next Page
Loading...
Need help?
General
