Keysight MP4300 Series User Manual

OUTPut:PON:STATe RST|RCL0
OUTPut:PON:STATe?
Sets the output power-on state. This determines whether the power-on state is set to the *RST state
(RST) or the state stored in memory location 0 (RCL0).Instrument states can be stored using the *SAV
command. This parameter is saved in non-volatile memory.
Parameter Typical Return
RST | RCL0 RST or RCL0
Sets the power-on state to the *RST state: OUTP:PON:STAT RST
l
If the power-on state is set to 0 with no state stored, a self-test error "file not found; 0 state" is gen-
erated and the instrument is set to the *RST state.
OUTPut:PROTection:CLEar (@<chanlist>)
Resets the latched protection. This clears the latched protection status that disables the output when
a protection condition occurs (see Programming Output Protection).
Parameter Typical Return
<chanlist> one or more channels (none)
Clears the latched protection status on channel 1: OUTP:PROT:CLE (@1
l
All conditions that generate the fault must be removed before the latched status can be cleared.
The output is restored to the state it was in before the fault condition occurred.
OUTPut:PROTection:COUPle[:STATe] 0|OFF|1|ON
OUTPut:PROTection:COUPle[:STATe]?
Enables or disables channel coupling for protection faults. When enabled, ALL output channels are
disabled when a protection fault occurs on any output channel. When disabled, only the affected
output channel is disabled when a protection fault is triggered.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Turns the output coupling protection on: OUTP:PROT:COUP ON
Keysight MP4300 Series Operating and Service Guide 129
5 SCPI Programming Reference

Keysight MP4300 Series Specifications

General

Brand	Keysight
Model	MP4300 Series
Category	Power Supply
Language	English