Safety Notices
The following general safety precautions must be observed during all phases of operation of this
instrument. Failure to comply with these precautions or with specific warnings or instructions
elsewhere in this manual violates safety standards of design, manufacture, and intended use of the
instrument. Keysight Technologies assumes no liability of the customer’s failure to comply with the
requirements.
The equipment is for industrial use. Equipment operators are subject to all applicable safety
regulations. Along with the warning and safety notices in this manual, all relevant safety, accident
prevention, and environmental regulations must also be followed. In particular, the operators of the
equipment:
l
Must be informed of the relevant safety requirements.
l
Must have read and understood the operating manual before using the equipment.
l
Must use the designated and recommended safety equipment
General
Do not use this product in any manner not specified by the manufacturer. The protective
features of this product may be impaired if it is used in a manner not specified in the
operating instructions.
Environmental Condition
Never use the instrument outside of the specified environmental conditions described in
the Environmental Characteristics of the specifications.
Heavy Weight
Danger to hands and feet. To avoid personal injury and damage to the instrument,
always use a sturdy cart or other suitable device to move the instrument. Do not lift the
instrument alone; always use two people to lift the instrument.
SHOCK HAZARD Ground the Instrument
This product is provided with a protective earth terminal. To minimize shock hazard, the
instrument must be connected to the ac mains through a grounded power cable, with
the ground wire firmly connected to an electrical safety ground at the power outlet. Any
interruption of the protective ground conductor or disconnection of the protective earth
terminal will cause a potential shock hazard that could result in injury or death.
Before Applying Power
Verify that all safety precautions are taken. All connections must be made with the unit
turned off, and must be performed by qualified personnel who are aware of the hazards
involved. Improper actions can cause fatal injury as well as equipment damage. Note the
instrument's external markings described under "Safety Symbols".
Keysight MP4300 Series Operating and Service Guide 10
Legal and Safety Information
To Next Page
Loading...
Need help?
General
